Bricx Command Center / Support Requests / #33 cos causing file error

#33 cos causing file error

Status: open

Owner: John Hansen

Labels: None

Priority: 5

Updated: 2010-10-04

Created: 2010-10-04

Creator: ForgottenRomeo

Private: No

I am trying to use the tachometer in the motors for odometry, yet when I use cos or Cos (as i have tried them both) I get a file error message on the nxt lcd screen. I already have the enhanced firmware checked on the compiler options, any suggestions on how to fix this or work around it will be appreciated.

Discussion

John Hansen - 2010-10-04

assigned_to: nobody --> afanofosc_99
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

John Hansen - 2010-10-04

Could you post about this issue on the new forums.mindboards.net site? It will be easier to sort out the issues there. If you have a sourceforge account you should be able to post on the forums. I'd like to see your source code and a screenshot of the compiler options page in BricxCC as well as the About box which shows the version information.

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

ForgottenRomeo - 2010-10-04

https://sourceforge.net/apps/phpbb/mindboards/viewtopic.php?f=3&t=56

here is a link to the one on the new forum

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

cos causing file error

Group

Searches

Help

#33 cos causing file error

Discussion