#192 Gionee M3 MTP mode support needed

Marcus Meissner — Mon, 30 Nov 2015 18:22:22 -0000

status: open --> pending
assigned_to: Marcus Meissner

Gionee M3 MTP mode support needed

Abraham — Mon, 23 Nov 2015 11:22:29 -0000

I have a Gionee M3 Android phone with Mediatek 6582 chipset. When switched off and connected, device id (0e8d,2000) is shown and " device xy was not an MPT device " error message appears. I am trying to flash the firmware update. When Switched ON, the device id is (271d,3c03) and another mode for camera photos also is there with the id (271d,400c). I have the module cdc-acm added to /etc/modules to support the phone when switched off. Please add support for Gionee M3.
Note: It is detected fine in adb and fastboot with custom udev rules added.

OS: Debian Jessie. Problem with 4.2.0-0.bpo.1-amd64 and stock 3.16 kernel.
Libmtp version: 1.1.10-1~bpo8+1

When Switched OFF: (0e8d,2000), When Vol UP button is pressed, system recovery menu shows up.

Nov 21 14:04:07 mintbox kernel: [ 6890.940033] usb 4-1.2: new high-speed USB device number 11 using ehci-pci
Nov 21 14:04:07 mintbox kernel: [ 6891.033900] usb 4-1.2: New USB device found, idVendor=0e8d, idProduct=2000
Nov 21 14:04:07 mintbox kernel: [ 6891.033906] usb 4-1.2: New USB device strings: Mfr=1, Product=2, SerialNumber=0
Nov 21 14:04:07 mintbox kernel: [ 6891.033908] usb 4-1.2: Product: MT65xx Preloader
Nov 21 14:04:07 mintbox kernel: [ 6891.033910] usb 4-1.2: Manufacturer: MediaTek
Nov 21 14:04:07 mintbox kernel: [ 6891.095953] cdc_acm 4-1.2:1.1: ttyACM0: USB ACM device
Nov 21 14:04:07 mintbox mtp-probe: checking bus 4, device 11: "/sys/devices/pci0000:00/0000:00:1d.0/usb4/4-1/4-1.2"
Nov 21 14:04:07 mintbox mtp-probe: bus: 4, device: 11 was not an MTP device
Nov 21 14:04:10 mintbox kernel: [ 6894.255981] usb 4-1.2: USB disconnect, device number 11

When Switched OFF and press the Vol DOWN arrow, the product id gets changed, but phone goes to FACTORY mode. - (0e8d,0003)

Nov 23 16:38:38 mintbox kernel: [ 3919.690321] usb 2-1.2: new full-speed USB device number 11 using ehci-pci
Nov 23 16:38:38 mintbox kernel: [ 3919.783130] usb 2-1.2: New USB device found, idVendor=0e8d, idProduct=0003
Nov 23 16:38:38 mintbox kernel: [ 3919.783136] usb 2-1.2: New USB device strings: Mfr=0, Product=0, SerialNumber=0
Nov 23 16:38:38 mintbox kernel: [ 3919.784037] cdc_acm 2-1.2:1.0: ttyACM0: USB ACM device
Nov 23 16:38:38 mintbox mtp-probe: checking bus 2, device 11: "/sys/devices/pci0000:00/0000:00:1d.0/usb2/2-1/2-1.2"
Nov 23 16:38:38 mintbox mtp-probe: bus: 2, device: 11 was not an MTP device
Nov 23 16:38:43 mintbox kernel: [ 3924.420947] usb 2-1.2: USB disconnect, device number 11
Nov 23 16:38:44 mintbox kernel: [ 3925.658174] usb 2-1.2: new high-speed USB device number 12 using ehci-pci
Nov 23 16:38:44 mintbox kernel: [ 3925.752051] usb 2-1.2: New USB device found, idVendor=0e8d, idProduct=2000
Nov 23 16:38:44 mintbox kernel: [ 3925.752057] usb 2-1.2: New USB device strings: Mfr=1, Product=2, SerialNumber=0
Nov 23 16:38:44 mintbox kernel: [ 3925.752060] usb 2-1.2: Product: MT65xx Preloader
Nov 23 16:38:44 mintbox kernel: [ 3925.752062] usb 2-1.2: Manufacturer: MediaTek
Nov 23 16:38:44 mintbox kernel: [ 3925.814148] cdc_acm 2-1.2:1.1: ttyACM0: USB ACM device
Nov 23 16:38:44 mintbox mtp-probe: checking bus 2, device 12: "/sys/devices/pci0000:00/0000:00:1d.0/usb2/2-1/2-1.2"
Nov 23 16:38:44 mintbox mtp-probe: bus: 2, device: 12 was not an MTP device
Nov 23 16:38:47 mintbox kernel: [ 3928.592445] usb 2-1.2: USB disconnect, device number 12

When Phone is switched on and storage is selected: (271d,3c03)

Nov 23 16:28:11 mintbox kernel: [ 3292.982184] usb 2-1.2: new high-speed USB device number 7 using ehci-pci
Nov 23 16:28:11 mintbox kernel: [ 3293.075539] usb 2-1.2: New USB device found, idVendor=271d, idProduct=3c03
Nov 23 16:28:11 mintbox kernel: [ 3293.075553] usb 2-1.2: New USB device strings: Mfr=2, Product=3, SerialNumber=4
Nov 23 16:28:11 mintbox kernel: [ 3293.075556] usb 2-1.2: Product: M3
Nov 23 16:28:11 mintbox kernel: [ 3293.075558] usb 2-1.2: Manufacturer: GIONEE
Nov 23 16:28:11 mintbox kernel: [ 3293.075560] usb 2-1.2: SerialNumber:
Nov 23 16:28:11 mintbox kernel: [ 3293.076529] usb-storage 2-1.2:1.0: USB Mass Storage device detected
Nov 23 16:28:11 mintbox kernel: [ 3293.076752] scsi host7: usb-storage 2-1.2:1.0
Nov 23 16:28:11 mintbox mtp-probe: checking bus 2, device 7: "/sys/devices/pci0000:00/0000:00:1d.0/usb2/2-1/2-1.2"
Nov 23 16:28:11 mintbox mtp-probe: bus: 2, device: 7 was not an MTP device
Nov 23 16:28:12 mintbox kernel: [ 3294.074978] scsi 7:0:0:0: Direct-Access GIONEE M3 0000 PQ: 0 ANSI: 2
Nov 23 16:28:12 mintbox kernel: [ 3294.075448] scsi 7:0:0:1: Direct-Access GIONEE M3 0000 PQ: 0 ANSI: 2
Nov 23 16:28:12 mintbox kernel: [ 3294.075801] sd 7:0:0:0: Attached scsi generic sg3 type 0
Nov 23 16:28:12 mintbox kernel: [ 3294.076054] sd 7:0:0:1: Attached scsi generic sg4 type 0
Nov 23 16:28:12 mintbox kernel: [ 3294.079528] sd 7:0:0:0: [sdc] Attached SCSI removable disk
Nov 23 16:28:12 mintbox kernel: [ 3294.080148] sd 7:0:0:1: [sdd] Attached SCSI removable disk
Nov 23 16:28:16 mintbox kernel: [ 3297.898799] usb 2-1.2: USB disconnect, device number 7

When Switched ON with media(photos only) mode in Phone: (271d,0001)

Nov 21 14:02:50 mintbox kernel: [ 6814.198117] usb 4-1.2: USB disconnect, device number 9
Nov 21 14:02:50 mintbox kernel: [ 6814.397874] usb 4-1.2: new high-speed USB device number 10 using ehci-pci
Nov 21 14:02:50 mintbox kernel: [ 6814.491441] usb 4-1.2: New USB device found, idVendor=271d, idProduct=0001
Nov 21 14:02:50 mintbox kernel: [ 6814.491455] usb 4-1.2: New USB device strings: Mfr=2, Product=3, SerialNumber=4
Nov 21 14:02:50 mintbox kernel: [ 6814.491457] usb 4-1.2: Product: M3
Nov 21 14:02:50 mintbox kernel: [ 6814.491459] usb 4-1.2: Manufacturer: GIONEE
Nov 21 14:02:50 mintbox kernel: [ 6814.491462] usb 4-1.2: SerialNumber:
Nov 21 14:02:50 mintbox kernel: [ 6814.492388] usb-storage 4-1.2:1.0: USB Mass Storage device detected
Nov 21 14:02:50 mintbox kernel: [ 6814.492523] scsi13 : usb-storage 4-1.2:1.0
Nov 21 14:02:50 mintbox mtp-probe: checking bus 4, device 10: "/sys/devices/pci0000:00/0000:00:1d.0/usb4/4-1/4-1.2"
Nov 21 14:02:50 mintbox mtp-probe: bus: 4, device: 10 was not an MTP device
Nov 21 14:02:51 mintbox kernel: [ 6815.490501] scsi 13:0:0:0: Direct-Access GIONEE M3 0000 PQ: 0 ANSI: 2
Nov 21 14:02:51 mintbox kernel: [ 6815.490919] scsi 13:0:0:1: Direct-Access GIONEE M3 0000 PQ: 0 ANSI: 2
Nov 21 14:02:51 mintbox kernel: [ 6815.491244] sd 13:0:0:0: Attached scsi generic sg3 type 0
Nov 21 14:02:51 mintbox kernel: [ 6815.491542] sd 13:0:0:1: Attached scsi generic sg4 type 0
Nov 21 14:02:51 mintbox kernel: [ 6815.497303] sd 13:0:0:0: [sdc] Attached SCSI removable disk
Nov 21 14:02:51 mintbox kernel: [ 6815.497922] sd 13:0:0:1: [sdd] Attached SCSI removable disk
Nov 21 14:02:56 mintbox kernel: [ 6820.105919] usb 4-1.2: USB disconnect, device number 10

Another id I remember is (271d,0001) which I forgot to remember.

Gionee M3 MTP mode support needed

Abraham — Mon, 23 Nov 2015 11:22:29 -0000

Ticket 192 has been modified: Gionee M3 MTP mode support needed
Edited By: Marcus Meissner (marcusmeissner)
Status updated: u'open' => u'pending'
Owner updated: None => u'marcusmeissner'

Recent changes to 192: Gionee M3 MTP mode support needed

#192 Gionee M3 MTP mode support needed

Gionee M3 MTP mode support needed

Gionee M3 MTP mode support needed